Kenton Prophet V (before Feb 05) Manual de usuario descargar pdf

KENTON

electronics

INSTRUCTIONS FOR MIDI INTERFACE

SEQUENTIAL CIRCUITS PROPHET 5

USING THE MIDI INTERFACE

When you turn on the synthesizer for the first time, you will be in omni-on mode for receive (all channels) and

channel 1 for transmit - See next page for factory default settings When you select a transmit or receive channel,

this will be stored in memory and will be remembered for when you subsequently turn on the synth - all parameters

listed on the next page are stored.

If you want to put the machine back to the factory default settings at any time, switch the synth on whilst holding

the red push button pressed - hold for a couple of seconds then release.

RED PUSH BUTTON

Three modes are available by pushing the red push button. Before you press the red button however, make sure

that no notes are pressed on the synth otherwise the results may be unpredictable.

1) PATCH CHANGE MODE

Pressing once only enters patch change mode. Any key then selects a patch change which it sends through

MIDI. You are then automatically returned to playing mode.

2) SET-UP MODE

Setting MIDI channels and assignments. Give the red push button two short presses (half a second each) - then

release. Follow this with a note or sequence of notes as detailed on page 2. After selecting a channel you will be

automatically returned to playing mode but after making assignments you will need to press the ENTER key (Top

C) to return to playing mode. This is to enable you to make the multiple key presses required when re-assigning

sources to destinations. (N.B. set-ups are stored in non volatile memory).

3) TRANSPOSE MODE

Press and hold the red push button for four seconds - then release. Middle C will sound on the synth and

continue to sound until you press a key. The note that you press will be the new middle C for MIDI IN. You can set

any value up to two octaves up or down. Settings outside this range will be ignored. Note that transpose mode

cannot be entered from program mode.

ASSIGNING MIDI CONTROL SOURCES TO DESTINATIONS

SOURCES DESTINATIONS (d)=factory default

AFTERTOUCH off / modulation (d)/ p.bend / vcf / resonance

CONTROLLER X off / vcf (d) / not used

CONTROLLER Y off / vcf / resonance (d)

VELOCITY off (d) / vcf / vca

MIDI VOLUME off / vca (d)

Sources can control more than one destination at once, but a destination can only be controlled by one source at

a time. Thus if velocity is currently controlling VCF and then you switch aftertouch to VCF, velocity will then control

nothing until re-assigned.

1 2 3 4

Indice de contenidos

Pagina 1 - SEQUENTIAL CIRCUITS PROPHET 5

KENTONelectronicsINSTRUCTIONS FOR MIDI INTERFACESEQUENTIAL CIRCUITS PROPHET 5USING THE MIDI INTERFACEWhen you turn on the synthesizer for the first ti

Pagina 2

C Receive channel 1 [ Bottom C ] MIDI note number 36Db " " 2D " " 3Eb " " 4E" " 5F " " 6Gb &q

Pagina 3 - MIDI CONNECTORS

1) Controller X can be any MIDI controller. After pressing the red push button twice to enter SET-UP mode,operate the required MIDI controller before

Pagina 4 - WARRANTY

MIDI OUT is the signal from the synthesizer (or drum machine etc.) that is to be sent to another instrument. MIDIIN is a received signal that contain

Comentarios a estos manuales

Sin comentarios

Kenton Prophet V (before Feb 05) Manual de usuario

Busca en linea o descarga Manual de usuario para Equipo Kenton Prophet V (before Feb 05). Kenton Prophet V (before Feb 05) User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Kenton Prophet V (before Feb 05)